做【头追】刻FUTABA教练口的小PCB，顺便刻了个【离心式折叠四轴】的中心板。

njzcwn

感谢分享

我爱航魔

long0001 发表于 2014-11-16 11:53
19楼下载17个文件解压就ok

非常感谢

pangyong827

long0001 发表于 2014-11-16 11:52
论坛上传附件不能大于300k，所以压成17个文件。下载解压就行了。

已下载，道一声感谢！祝健康快乐！

阿琨

你好，请教一个问题，我也是用的pro mini，按教程链接好后，下载了最新的固件版本DIY_Headtracker_V1_04，但下载到pro mini的时候出现错误，端口、板、处理器选择promini和接线都没问题，请教一下是什么原因
试过早期版本的固件也提示错误

Arduino:1.6.0 (Windows 8), 板："Arduino Pro or Pro Mini, ATmega328 (5V, 16 MHz)"

Sketch uses 21,804 bytes (70%) of program storage space. Maximum is 30,720 bytes.

全局变量使用了1,386字节，(67%)的动态内存，余留662字节局部变量。最大为2,048字节。

avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x01
上传出错。查看页面 http://www.arduino.cc/en/Guide/Troubleshooting#upload 获取建议。

  报告将会包含更多的信息
  "Show verbose output during compilation"
  在 文件>首选项 中启用

莫须有言

有没有视频效果图

maillanyu2004

已下载到资源，道声谢谢！感谢楼主的分享

13624810703

遥控器里怎么设置